Turbulence intensity
From CFD-Wiki
(Difference between revisions)
(minor corrections) |
m (minor addition) |
||
| Line 9: | Line 9: | ||
If the turbulent energy, <math>k</math>, is known <math>u'</math> can be computed as: | If the turbulent energy, <math>k</math>, is known <math>u'</math> can be computed as: | ||
| - | :<math>u' = \sqrt{\frac{2}{3}\, k}</math> | + | :<math>u' \equiv \sqrt{\frac{1}{3} \, ( u_x'^2 + u_y'^2 + u_z'^2 )} = \sqrt{\frac{2}{3}\, k}</math> |
<math>U</math> can be computed from the three mean velocity components <math>U_x</math>, <math>U_y</math> and <math>U_z</math> as: | <math>U</math> can be computed from the three mean velocity components <math>U_x</math>, <math>U_y</math> and <math>U_z</math> as: | ||
Revision as of 20:28, 23 March 2006
Definition
The turbulence intensity is defined as:
Where 
is the root-mean-square of the turbulent velocity fluctuations and 
is the mean velocity (Reynolds averaged).
If the turbulent energy, 
, is known can be computed as:
can be computed from the three mean velocity components 
, 
and 
as:
Estimating the turbulence intensity
When setting boundary conditions for a CFD simulation it is often necessary to estimate the turbulence intensity on the inlets. To do this accurately it is good to have some form of measurements or previous experince to base the estimate on. Here are a few examples of common estimations of the incoming turbulence intensity:
- High-turbulence case: High-speed flow inside complex geometries like heat-exchangers and flow inside rotating machinery (turbines and compressors). Typically Tu is between 5% and 20%
- Medium-turbulence case: Flow in not-so-complex devices like large pipes, ventilation flows etc. or flow with low speed (low Reynolds number). Typically Tu is between 1% and 5%
- Low-turbulence case: Flow originating from a fluid that stands still, like the flow across cars, submarines and aircrafts. Very high-quality wind-tunnels can also reach really low turbulence levels. Typically Tu is very low, well below 1%. In this case Tu is normally not used directly to set the inlet conditions for a CFD simulation. Instead a typical eddy viscosity ratio is estimated.
